Assembling a metal adjustable hammock stand may seem daunting, but it can be done quickly and easily with the right tools and instructions. This guide will walk you through the steps to assemble an adjustable hammock stand.
- Confirm that there are 7 individual pieces: 2 end tubes(A1, A2), 2 bending tubes(B1, B2), 2 base brackets(C1, C2), a adjustable connection (D).
- Place B1 B2 into C1 C2, align the holes, and use the screw to fasten securely.
- Insert two combinations into D, adjust the suitable station, align the holes, and use the screw to fasten securely.
- And then insert A1 A2 into B1 B2.
- Double-check each screw to confirm that they have been thoroughly screwed in.
- Hang your hammock (with or without a wooden spreader bar hammock) on the stand and adjust the length to be matched.
In conclusion, assembling an adjustable hammock stand requires basic DIY skills and some patience. Always refer to the instruction manual and follow the steps carefully to assemble the stand correctly. With proper assembly, your adjustable hammock stand will provide a comfortable and relaxing experience for many years.
Warning:
- This hammock with a stand is not intended to be used as a swing and will not support the perpendicular motion. Monitor the welds periodically and place your hammock stand in a dry place during the winter season.
- The hammock with a stand must be put on flat ground. If the ground has a slope, the max slope is 10 degrees.
- The appliance is designed for adult use only by private. Age grading (14+)
- Delivery to min. Required clearance with deflection of 15°.
- The distance between the hammock and the ground is not exceeding 60cm.
- If a lying/seat height loaded with a rated load is greater than 600mm above the installation site, the product must not be used on/over hard floors(for example, tiles, concrete, pavement…)
- Use only the accessories and spare parts approved by the manufacturer.
- The danger in case of incorrect installation
- Do not use the hammock/hanger seat if parts are damaged or lost.
- Use only the accessories and spare parts approved by the manufacturer.
- Do not leave your child unattended.
- The hammock is not a rocking device.
- Finally, use the hammock stand within the weight capacity of 200kgs.
Clean and Care:
- Clean the cover with a mild household cleaner and warm water only.
- Never use cleaning agents containing solvents. Finally, wipe the cover with a dry cloth.
- Protect the hammock from extreme weather conditions.
- Do not use the hammock in wet conditions or strong direct sunshine.
- Clean and let it dry before storing.
- Fastening elements and wearing parts should be regularly examined for tight fit and wear.
- The metal hammock stand is made of powder-coated steel and should be handled with care.
For more instruction: ASSEMBLY INSTRUCTIONS FOR DOUBLE HAMMOCK